• visual control of working forces of roughing and finishing rolling mills
• forming of analog or relay signals
• recording and restoring of information about average and maximum rolling force for each transition

FUNCTIONAL CAPABILITIES

• displaying on indicator board, preview and printing of digital and graphical information about average and maximum pressure force in each transition with the indication of date and time

• data restore

• forming of output analog signals proportional to forces recorded on left and right sensor, as well as the aggregated rolling forces

• forming of the pressure presence and pressure overload relay signals

• diagnosis of sensor efficiency, automatic switching into emergency mode and formation of "failure" signal.

• creation of protocols for exceeding rolling technology standards

STANDARD EQUIPMENT

• a set of sensors to measure pressure (DSK)
  
• microprocessor data processing unit
  
• indicator board

Force sensor mounted at the bottom of swinging blocks in lower part of rolling mill.

FUNCTIONAL CAPABILITIES OF DSK

• forming differential analog signal proportional to the force acting on DSK

• transmission on demand of information about the temporary loads on the sensor via the RS 485 interface

• transmission on demand of information about redistribution of weights in the sensor cross-section via the RS 485 interface

• automatic zero calibration

• linearization of indications in the entire range of loads

• sensor checking and diagnosis

• voltage control

• automatic calibration of the linearity and sensitivity after connection of standard sensor[/size]

Range of measured rolling forces *

Maximum rolling force

Minimum rolling force

Maximum permissible errors

Maximum load on sensor , % Pnom.

Number of emergency modes

Working temperature range, C:

Size converter *